The Lint Bucket

 
mailto:contact@tugnomore.com?subject=Tell%20me%20about%20The%20Lint%20Bucket!
 

Eliminate the need to ever purchase another disposable lint trap!

SAVE YOUR MONEY!

  1.   Eliminate the need to call a plumber to fix clogged pipes!

SAVE YOUR MONEY!

  1.   An ingenious use of new and recycled materials.

  2.   Brand new, super strong vinyl-coated polyester reusable mesh filter: remove, clean and reuse in seconds!

  3.   Over twice as much reusable mesh filter surface area than traditional disposable lint traps!

  4.   No need to tie or clamp a lint trap to your washing machine hose!

SAVE YOUR TIME!

  1.   No need for clamps, plastic ties or tools ever again!

SAVE YOUR MONEY!

  1.   Simply hang "The Lint Bucket" anywhere on the inside lip of your laundry tub under your washing machine discharge hose. Manipulate the wire hanger to fit your laundry tub if needed.

Why purchase The Lint Bucket?

Contact Usmailto:contact@tugnomore.com?subject=Tell%20me%20about%20The%20Lint%20Bucket
$9.95
mailto:contact@tugnomore.com?subject=Lint%20Bucket%20International%20Shipping
Shipping 
 outside US?
Contact Usmailto:contact@tugnomore.com?subject=Lint%20Bucket%20International%20Shipping
FREE 
US 
Shipping!

©2011 Tug-No-More, LLC

Cleaning The Lint Bucket!

  1.   Simply remove the reusable mesh filter, unroll and clean.

Please note: Lint can build-up and form a dry hardened paste.

Only attempt to unroll and clean if mesh filter is moist with water.

  1.   Do not attempt to clean a dry mesh filter (you could damage/rip the mesh filter). Use a wet soft bristle brush or wet rag to remove lint from the unrolled wet/moist mesh filter. Avoid cleaning mesh filter near a sink drain where lint could be flushed down the drain defeating the entire purpose why you purchased the The Lint Bucket in the first place! Trust me, it happens…

  2.   To reinstall the reusable mesh filter, roll mesh filter back to the circumference of the plastic support canister with numbers on the outside. Fold the bottom six mesh flaps based on the labeled numeric flaps. Align the two “1’s” and the two “2’s” together. Then fold the flaps in numeric order: 1’s first, 2’s second, 3, and then flap number 4 so they lay flat at the bottom of the plastic support canister. Slide paperclip to hold all flaps together. Insert the reusable mesh filter so folded flaps lay flat at the bottom of the plastic support canister.